Boss Snowplow VBX 6500, Руководство пользователя

Страница: 12 / 32

g029492
Figure 11
1. Adjustment assembly 4. Spinner assembly
2. Thumb screw 5. Cotter pin
3. Flat washer (5/16 inch) 6. Latch pin
2. Remove and retain the latch and cotter pins
from the spinner assembly (
Figure 11 ).
3. Attach the spinner assembly to the spreader and
secure it with the previously removed latch and
cotter pins (
Figure 11 ).
Important:
The spinner assembly is heavy
and requires 2 people to lift.
4. Connect the wire harness.
Installing the Spreader
Controller
Mount the controller in the cab where it does not
interfere with vehicle operation or visibility.
Important:
Do not mount the controller in a
location that vehicle occupants could contact it
during a crash.
1. Attach the mounting bracket to the vehicle
using either 2 hook and loop fasteners or 2
sheet-metal screws (
Figure 12 ).
g029493
Figure 12
1. Controller display 5. Mounting bracket
2. Sliding bracket 6. Pan-head screws
3. Sheet-metal screws
7. Thumb nut
4. Carriage bolt
2. Connect the controller display to the sliding
bracket using 4 pan-head screws (
Figure 12 ).
3. Attach the sliding bracket to the mounting
bracket using 2 carriage bolts and thumb nuts
(
Figure 12 ).
Note:
Position the controller screen so that it is
clearly visible to the driver.
4. Connect the wire harness controller connector
to the controller display.
Checking the Installation
1. For models VBS14210B, VBS15310B, and
VBS15160B, check the pintle chain conveyor
tension; refer to
Adjusting the Pintle-Chain
Conveyor Tension (page 20) .
2. Check that the unit type listed on the controller
display matches your machine type; refer to the
Main Screen (page 14) section.
Note:
If the unit type does not match your
machine, contact your Authorized BOSS Dealer
about adjusting the control module.
12