Boss Snowplow Drag Pro 180Z, Руководство пользователя

Страница: 14 / 32

g333870
Figure 31
1. Brown wire with large ring
connector 3. Red wire
2. Black power/ground cable
4. Battery cable
18. Connect the brown wire with the large ring
connector from the wire harness to the negative
(-) battery terminal (
Figure 31 ).
19. Connect the free end of the battery cable to the
positive (+) battery terminal (
Figure 31 ).
20. Route the plow connector and power/ground
connector along the vehicle frame to the rear
bumper.
21. Mount the plow connector and the black and red
power/ground connector to the lower part of the
rear bumper using a cable tie (
Figure 32 ).
g252335
Figure 32
1. Power/ground connector 2. Plow connector
22. Secure the wire harness to the vehicle frame
using cable ties.
Important:
Ensure that all wiring is secured
in a position that avoids hot or moving parts
to prevent damage to the vehicle or plow.
Mounting the Plow
Controller
Note:
Mount the controller in the cab in a dry area
where it does not interfere with vehicle operation or
visibility.
Important:
Do not install the swivel mount when
temperatures are below 16°C (60°F).
DANGER
The controller could cause serious injury if
contacted during a crash.
Mount the controller in a location that vehicle
occupants will not contact during a crash.
1. Determine the mounting location for the
controller.
2. Clean the location with the provided alcohol
wipe and dry it with a cloth or paper towel.
3. Clean the back of the swivel mount ( Figure 33 )
with the alcohol wipe and then dry it.
g032942
Figure 33
1. Swivel mount 2. Mounting tab
4. Remove the backing from 1 side of the adhesive
and apply it to the back of the swivel mount.
5. Remove the remaining backing from the
swivel-mount adhesive and press the swivel
mount to the clean area of the dashboard for 30
seconds.
Important:
Once the mount is placed, you
cannot remove it without destroying the
adhesive.
6. Clean the back of the controller with the alcohol
wipe and then dry it.
7. Remove the backing from 1 side of the adhesive
and apply it to the back of the mounting tab
(
Figure 33 ).
8. Remove the remaining backing from the
controller adhesive and press the mounting tab
to the controller for 30 seconds.
14