Boss Snowplow Drag Pro 180Z, Руководство пользователя

Страница: 12 / 32

g333865
Figure 26
Installing the Blade Guides
and Filling the Hydraulic
Reservoir
1. Attach the blade guides to the wing blade using
4 bolts (5/16 x 1 inch) and locknuts.
g332361
Figure 27
2. Torque the bolts to 19 N∙m (14 ft-lb).
3. Lift the hood from the manifold box, and remove
the fill cap from the hydraulic reservoir (
Figure
28 ).
g332354
Figure 28
4. Slowly fill the reservoir with 1.9 L (2 US qt) of
fluid.
5. Run the plow to fill the cylinders and hydraulic
lines with fluid. Top off the fluid as need; refer to
Adding Hydraulic Fluid (page 24) .
6. Install the previously removed fill cap and secure
the manifold box lid.
Installing the Wire Harness
WARNING
Using a drill without proper eye protection
may allow debris to enter the eye, causing
injury.
When drilling, always wear eye protection.
DANGER
Vehicle engines contain moving parts and can
become extremely hot, capable of causing
severe burns and serious bodily harm.
Shut off the engine and allow it sufficient time
to cool down before installing this kit.
DANGER
Vehicle batteries can cause dangerous
electrical shocks that could lead to severe
burns or death.
Disconnect your battery before installing this
kit. Remove the negative cable first, then
remove the positive cable.
Note:
Apply dielectric grease to all electrical
connections.
1. Ensure that the vehicle firewall is clear of
obstructions.
12