Bosch Rexroth PSI 6100 L1 Series, Руководство по эксплуатации

Страница: 418 / 460

1070080028 / 08 Bosch Rexroth AG PSI 6xxx | 418 /460
Extension and conversion
13.2.2 Installation/Removal of the licence memory card
The Licence Memory Card (Micro SD memory card) serves in connec­
tion with PSI 6xCx.xxx for activating options such as the UI controller,
for which a license is required.
Licensed options are only available with installed card!
1
5
2 3
4
5
Fig.93: Location of the licence memory card
Proceed as follows:
1.
Make sure that the 24V logic supply of the timer has been switched
off!
2.
Remove control element of diagnosis module (4).
Press on the latching tongues (5) from above and below and pull the
control element off to the front.
The slot (2) for the license memory card (1) is now accessible.
3.
If there is a card in the slot already:
First press the installed card slightly into the slot. This unlocks the
card.
Then remove the unlocked card.
4.
Pay attention that the contact surfaces of the license memory card
are located at the back/right and push the card into the slot.
5.
Insert control element of diagnosis module (4).
The latching tongues (5) must snap back.
6.
Switch on the 24V logic supply of the timer.
7.
Check after booting the timer if the licenses are aktiv.
English