Bosch Rexroth Inline Series, Настройка и установка

Страница: 37 / 64

Mounting/Removing InlineTerminals and Connecting Cables
Application Description | Inline Electric Drives | Bosch Rexroth AG 31/58
and Controls
6 Mounting/Removing InlineTerminals and
Connecting Cables
.
6.1 Connecting the Voltage Supplies
To operate an Inline station you must provide the supply voltage for the bus
coupler, the logic of the terminals, and the sensors and actuators.
6.1.1 Bus Interface Module Supply
Depending on the bus coupler, there are various options for supplying supply
voltages.
As a rule, the 24 V bus coupler supply U
BK
must be supplied at a bus coupler.
The R-IBS IL 24 BK-T/U bus coupler offers the option of supplying all the required
24 V supply voltages at the bus coupler In this case, the following supply voltages
can be supplied or provided:
• 24 V bus coupler supply U
BK
• 24 V supply in the main circuit U
M
• 24 V supply in the segment circuit U
S
If U
M
and U
S
are not supplied at the bus coupler:
• Implement the 24 V supplies in the main circuit U
M
via a directly connected
power terminal.
• The 24 V supplies in the segment circuit U
S
can also be implemented at this
power terminal or an additional segment terminal.
As a rule, all the information in the corresponding chapter of the DOK-
CONTRL-ILSYSINS***-AW..-EN-P application description applies.
This section contains additional information that applies specifically
to bus couplers for INTERBUS.
Secure each Inline station using an end plate, which is supplied as
standard with the bus coupler, and an end clamp at the start and end
of the station.
For further information, please refer to the DOK-CONTRL-
ILSYSINS***-AW..-EN-P application description.
For information about which voltage is actually supplied at a specific
bus coupler, please refer to the terminal-specific data sheet.