Bosch ITS-DX4020-G, Инструкция по установке и эксплуатации

Страница: 37 / 52

GPRS/GSM IP Communicator Firmware Upgrade | en 37
Bosch Security Systems, Inc. Installation and Operation Guide F01U163066 | 01 | 2010.05
Figure 6.3 Xmodem File Send Progress Dialog Box
14. When the file transfer completes, HyperTerminal prompts you to continue. Press [Y] and
then [Enter] to continue the upgrade.
15. When the firmware upgrade is complete, close Hyper Terminal, and remove the jumper
plug from the CONFIG MODE jumpers on the ITS-DX4020-G. The ITS-DX4020-G restarts.
6.2.2 Install the Firmware using Tera Term
If you are using Microsoft Windows Vista or 7, you must download and install a
communication utility, such as Tera Term, on the target PC or laptop.
1. Ensure that the USB-to-mini-USB cable is connected to the ITS-DX4020-G and the target
PC or laptop.
2. Short the CONFIG MODE jumper pins with the supplied jumper plug.
3. Start Tera Term by selecting Start>(All) Programs>Tera Term>Tera Term .
4. Set up a connection on the new virtual serial COM port (for example, Port: COM4:
ITS-DX4020-G [COM4]) using the following settings:
– Baud rate: 9600
– Data bits: 8
– Parity: None
– Stop bits: 1
– Flow control: None
5. After the connection is established, press the [Enter] key.
The ITS-DX4020-G USB login window opens. Figure 6.4 , Page 38 .
NOTICE!
The CONFIG MODE jumper pins must be shorted together with the supplied jumper plug to
install firmware. Refer to Table 7.2 , Page 43 for LED activity.