Bosch ITS-DX4020-G, Инструкция по установке и эксплуатации

Страница: 11 / 52

GPRS/GSM IP Communicator Installation | en 11
Bosch Security Systems, Inc. Installation and Operation Guide F01U163066 | 01 | 2010.05
3 Installation
3.1 Installation Prerequisites
Before you install the ITS-DX4020-G, ensure that the following prerequisites are met:
– Before installing the ITS-DX4020-G in an existing system, inform the operator and local
authority.
– Before installing the ITS-DX4020-G, disconnect all system power (AC and standby
battery).
– If you are mounting the ITS-DX4020-G in a separate enclosure in a burglary application, a
tamper switch is required in the enclosure. For fire applications, the tamper switch is not
required. Refer to Section 1.2 Technical Specifications, page 5 , for enclosure options.
– If you are mounting the ITS-DX4020-G in a separate enclosure and using GSM (PSTN)
mode, ensure that all external wiring between and originating from the enclosures is in a
metal conduit no longer than 6 m (20 ft), and is within the same room. Refer to
Section 1.2 Technical Specifications, page 5 for enclosure options.
– Separate power-limited wiring from non-power-limited wiring by 6.4 mm (0.25 in).
– For specific control panel installation instructions, refer to the control panel’s
documentation.
– Contact the central monitoring station for destination IP address and port number
settings. Provide the central monitoring station with the poll rate setting.
NOTICE!
Depending on the SIM card used, first-time registration of the SIM card might take up to 3
minutes to complete. During this time, the signal levels displayed by the signal strength LEDS
might fluctuate.