Bosch ITS-DX4020-G, Инструкция по установке и эксплуатации

Страница: 28 / 52

28 en | Configuration GPRS/GSM IP Communicator
F01U163066 | 01 | 2010.05 Installation and Operation Guide Bosch Security Systems, Inc.
Table 4.9 UL 864 Required Configuration Settings
Configuration ID Permitted in UL 864 (Y/N) Possible Settings Settings Permitted in UL 864
Enable Low Signal
Strength Reporting
(ID 59)
Y – 0 = Disabled
– 1 = Enabled
1 = Enabled
NOTICE!
Table 4.10 shows all parameters available through SMS or USB configuration.
Shaded rows are required parameters. Values in bold are default settings.
ID Parameter Values Description
1 Current Password 4 to 15 characters (4020G) Mandatory and case sensitive.
NOTICE!
Remember all passwords. Forgotten passwords
cannot be recovered, and the unit must be returned.
2 New Password 4 to 15 characters New password, as desired. Case sensitive.
3 SIM PUK,PIN Maximum 10 numeric digits each Sets a new PIN into the SIM and the ITS-DX4020-G.
4 SIM PIN 4 numeric digits Sets the PIN in the ITS-DX4020-G to match your SIM
card PIN.
10 GPRS APN 1 to 63 characters (Airnet1) Access point name.
11 GPRS username 1 to 63 characters User name for wireless service provider (not always
required).
12 GPRS password 1 to 63 characters Password for wireless service provider (not always
required).
13 Src port 1 to 65535 characters (7700) Sets the source port for the ITS-DX4020-G.
14 Bus Address – 88 (GV2 Series
or GV3 Series)
– 92 (GV3 Series)
– 134 (default)
– 250 (FPD-7024)
Sets the control panel bus address for
communication with the control panel.
15 AES Encryption 0 = Disabled
1 = Enabled
Security encryption on or off. The setting must
match the encryption settings in the receiver.
16 AES Encryption Key 32 characters max.
0-9, A-F, a-f allowed
The AES Encryption Key must match the encryption
key in the receiver.
17 Communication
paths available
– 1 = Both
– 2 = IP over GPRS
– 3 = PSTN (Contact ID) over
GSM
Select which communication path the
ITS-DX4020-G will use.
50 DTMF digit timeout 100 to 3000 ms (500 ms) Acceptable time between dialed DTMF digits from
the control panel.
51 GPRS ACK timeout 6 to 600 sec (70 sec) The GPRS session restarts if no response occurs by
the time the entered time expires.
52 GPRS Transmit
buffer lifetime
6 to 120 sec (15 sec) Length of time the control panel messages remain
in the in the ITS-DX4020-G buffer before they are
discarded.