Bosch ITS-DX4020-G, Инструкция по установке и эксплуатации

Страница: 18 / 52

18 en | Configuration GPRS/GSM IP Communicator
F01U163066 | 01 | 2010.05 Installation and Operation Guide Bosch Security Systems, Inc.
Refer to Section Multiple SMS Messages (for Messages Longer than 160 Characters), page 19 for
instructions for sending a multiple SMS configuration.
The templates below contain only the essential configuration IDs. For additional configuration
IDs, refer to Table 4.10, Page 30 .
Refer to Table 4.1 for information about the modes allowed for your control panel.
IP over GPRS Mode
Table 4.2 IP over GPRS Mode and Dual Wireless Mode SMS Configuration
NOTICE!
Separate each ID or value pair with a line feed (<LF>), a carriage return (<CR> or
< ENTER>), or a semi-colon <;>. Due to phone and carrier differences, Bosch recommends
using semi-colons to create and send SMS messages. For example,
%1;1=4020G;10=Airnet1;14=88;17=2;! . To allow spanning of configuration across multiple
messages, each SMS starts with the sequence number followed by the command line
separator.
Any of these characters is acceptable to separate command lines. Refer to your cellular
phone’s documentation for available characters.
ID Description Sample SMS
%1
SMS sequence number 1
1
1= Current password (4 to 15 characters); default = 4020G
10= GPRS access point name (APN); 1 to 63 characters
14= – 88 (GV2 Series or GV3 Series)
– 92 (GV3 Series)
– 134 (default)
– 250 (FPD-7024)
17= Communication path:
– 1 = Both (default)
– 2 = IP over GPRS
– 3 = PSTN (Contact ID) over GSM
! End of configuration
1
The % symbol starts the SMS configuration message content. Any data before the % symbol is discarded.
The % symbol is followed directly by the sequence number of the message (1 to 3).
%1
1=4020G
10=basic.m2m
14=88
17=2
!