bora PKA1UMEN-001, Инструкции по эксплуатации и монтажу

Страница: 37 / 44

EN
37
Cleaning and maintenance
www.bora.com
X X
Place the cover flap [3] on the side next to the exhaust
opening [1].
X X
Allow the cover flap [3] to slide vertically into the guide
[2].
X X
Gently press the narrow side of the cover flap [3] from
the top until you feel it slot into place.
X X
Make sure the cover flap [3] is correctly fitted.
INFO If the cover flap is not fully in the slot after
fitting, it cannot be closed properly.
INFO If the grease filter or the cover flap have not
been properly fitted, error message E0 12 or
E0 13 appears on the control knob display
(see Troubleshooting section).
8.2.4 Removing the maintenance tray
INFO The maintenance tray cannot be removed in
the following installation scenarios. Single
installation, adjacent 2nd extractor, adjacent
wok cooktop.
INFO To remove the maintenance tray, the grease
filter and the filter tray must first be removed.
2 1
Fig. 8.5 Removing the maintenance tray
[1] Maintenance tray
[2] Locking
X X
To unlock the maintenance tray [1], twist the two
locking levers [2] 90° outwards.
X X
Remove the maintenance tray [1] from the cooktop
extractor.
[1] Cover flap
[2] Grease filter
[3]
Filter tray
X X
Lift the cover flap [1] off upwards.
X X
Reach into the opening in the cooktop extractor and
remove the grease filter [2] and the filter tray [3].
8.2.3 Fitting the cover flap, the grease filter
and the filter tray
Fig. 8.3 Fitting the components
X X
Fit the filter tray into the exhaust opening.
X X
Insert the grease filter into the exhaust opening.
X X
Make sure the grease filter sits correctly in the opening
in the casing.
Inserting the cover flap:
1 2 3
Fig. 8.4 Inserting the cover flap
[1] Exhaust opening
[2] Guided tour
[3] Cover flap