FIRE AND ALARM CONSOLE
34
codes with corresponding authority levels are assigned in console configuration. Passwords
being programmed into the console have some numbers transmitting by the console in arm and
disarm messages as user’s identificators.
2.1.8
Console mounting
Console can be mounted in any convenient place on the wall or on the other constructions
protected from atmospheric condensation, mechanical damages and access of outliers.
2.1.9
Prevention of the accidents at device installation
Console construction satisfies requirements of electro and fire safety. Console has not
dangerous voltage circuits. Console construction provides its fire safety in accident regime and
in the case violation of maintenance rules. Mounting, setup, technical support have to be done
when console power off. Mounting and technical support of the console have to be done by
personnel with corresponded qualification access.
2.1.10
Console first starting
Check mounting before console will be turn on.
After console has been turned on LCD should be highlighted and should display message
about turning on. At device connection through RS-485 interface console send device detection
message. ‘Device reset’ (is formed by device at power on) and ‘Power down’ (is formed by some
device if power supply below the norm) messages can be shown. Last message device forms if
power is turned off, and at next the device connection console read it and display on the LCD. If
printer is on, then it should ptint the messages about console and printer turning on, console
connected device detection, and other messages.
It is recommended to change setup password, because user can get unauthorized access to
program functions. One or several user device control passwords have to be given (see. item
2.2.4.5).
To set the modes it is required to set the parameters ‘ALARM SOUND’ and ‘CODES
REQUIRED’. ‘ALARM SOUND’ parameter needs to be on if inner sound annunciator messages
should be alarmed, otherwise it has to be off. The default value is ‘on’. ‘CODES REQUIRED’
parameter determines if control functions are password protected. If the parameter has value
‘off’, then arming, disarming and other control functions are available without password. The
default value is ‘on’. These parameter settings are described in the item 2.2.4.4. It is necessary to
setup the current date and time. Time and date are required for event logging and for correct
working of time zones in access control devices (‘S2000-4’ and ‘S2000-2’). If clock is not
accurate, it can be corrected. Description of time and date input, and also clock correction is
shown in item 2.2.3.7 and in item 2.2.4.1.
2.2
Using console
Working with console functions is executed with the help of console menu. To select
function use keys ‘
t
‘, ‘
u
‘ and ‘ENT’, to cancel key ‘CLR’ is used.
Numbers can be entered either by typing from keypad or by choosing valid values from
the list with the help of ‘
t
‘ and ‘
u
‘ keys. For example, entering the device address one can
choose the address from the console polling device list.
If operation succeeded console send ‘Confirmation’ sound signal, otherwise it send sound
signal ‘Error’ with diagnostic LCD message. The following messages are possible:
‘COMMAND ERROR: DEVICE OFF LINE’ (command was given for disconnected device),
‘"COMMAND ERROR: UNKNOWN COMMAND’ (console do not support this command),
etc.
