A s s e m b l y S t e p 3
Hardware Required
Bolts
#22. Hex Bolt (M8x16xS14 mm)
[2 Pieces]
#35. Hex Bolt (M8x75x13xS14 mm)
[2 Pieces]
#10. Spring Washer (d8)
[2 Pieces]
#23. Washer (d8xφ32x2.0 mm)
[2 Pieces]
Washers
#30. Washer (d8xφ16x1.5 mm)
[2 Pieces]
#20. Special Washer (d19xφ25x0.3 mm)
[2 Pieces]
Nuts
#17. Nylon Nut (M8xH7.5xS13 mm) [2 Pieces]
B
Page 8
BRM8981
A.
Please use illustration “A” below as reference.
On the left side, ensure that one
Special Washer (#20)
is present (already pre-
assembled) on the
Center Post (#28). (Note:
Please be careful not to dispose of
Then slide on the
Left Couple
r
Bar (#25L)
, followed by one
Washer (#23)
, one
Spring Washer (#10)
, and secure with one
Hex Bolt (#22).
On the right side, ensure that one
Special Washer (#20)
is present (already pre-
assembled) on the
Center Post (#28)
.Then slide on the
Right Couple
r
Bar
(#25R)
, followed by one
Washer (#23)
, one
Spring Washer (#10)
, and secure
with one
Hex Bolt (#22)
.
B.
Referring to close-up illustration “B”, align the holes on the
Left Couple
r
Bar
(#25L)
to the front of the
Left Pedal Tube (#36L)
by inserting one
Hex Bolt (#35)
through the
Left Pedal Tube (#36L)
, the
Left Couple
r
Bar (#25L)
and secure with
one
Washer (#30)
and one
Nylon Nut (#17)
. Repeat this process on the right side.
A
A
Special Washers (#20)
when removing the protective packaging.)
Assembly Instructions
