BlueBox IDTRONIC UHF Advant 5238U-PN-C, Руководство пользователя

Страница: 28 / 71

BLUEBOX Advant Profinet Page 28 of 71
Where:
Parameter Description
Mode
Dynamic power management activation / deactivation in ‘continuous’ mode:
• 0x00: Off;
• 0x01: Up, only increase power by power step every time step;
• 0x02: Up / Down, increase power and then decrease it by power step every
time step.
Power Step
Power step:
• 0x0 1 … 0x05 for power step in dB (1 … 5 dB);
• 0x81 … 0xB2 for power step in mW x 10 (10 … 500 mW).
Time Step
Time step:
• Decimal 1 … 99 for time in ms x 100 (0.1 … 9.9 seconds).
The changed Dynamic Power Management parameters become
effective only after a reset of the
BLUEBOX . Reset the BLUEBOX
using the ‘Reset Device’ command or via a hardware reset.
3.3 Device Status
The information about the current status of the BLUEBOX shall be read with the
‘Read Device Status’ command as described in protocol technical manuals where
the status bytes 1 and 2 have the following meaning.
Status Byte Description
Status Byte 1
Byte whose bits have the following meaning:
• Bit 7: Not used
• Bit 6: Not used;
• Bit 5: RF status (0=off, 1=on)
• Bit 4: ‘Continuous’ mode (1=enabled)
• Bit 3: Not used
• Bit 2: Not used
• Bit 1: Output 2 status (1=activated)
• Bit 0: Output 1 status (1=activated)
Status Byte 2
Byte whose bits have the following meaning:
• Bit 7: Not used
• Bit 6: Not used
• Bit 5: Not used
• Bit 4: Not used