Blue Bird TC/2000, Руководство пользователя

Страница: 12 / 111

11
SEAT BELT INSPECTION & MAINTENANCE
Inspect seat belts and their attachments on a weekly basis. Check seat belt buckles and adjustability to
insure proper operation. If necessary, lubricate buckle with a graphite lubricant. When buckle is found to be
inoperable, replace immediately. If there are any defects in the webbing (i.e. torn or frayed), the seat belt must
be replaced as soon as possible to ensure passenger safety. Hand wash webbing with warm water and mild
soap. Rinse thoroughly and dry in the shade. Do not bleach or redye, because such processing may severely
weaken the assembly.
WARNING: Be sure the lap belt is fitted snugly around the hips, not the waist. Failure to do so may
increase the chance of injury in the event of a collision. Do not bleach or redye, because such processing
may severely weaken the assembly.
SEAT INSPECTION & MAINTENANCE
Blue Bird seats are built to meet Federal Motor Vehicle Safety Standards. In order to provide even safer
passenger transportation, the following guidelines should be met.
1. Inspect and retighten seat leg and wall side mounting bolts every 90 days.
2. Inspect and retighten cushion attachments with a Phillips head screwdriver on a weekly basis.
3. Inspect upholstery for cuts and tears every 90 days. If torn, remove upholstery by removing the staples
at the bottom front of seat back or bottom of cushion and remove cover. For installation of new cover,
reverse this procedure.
4. School bus seats are equipped with a special foam back pad. Should this pad ever become damaged,
it should be replaced with an approved replacement part. Aftermarket suppliers do exist and should
be checked for compliance with federal standards.
SEAT CARE AND CLEANING
It is imperative that the interior of the bus be kept clean and seats are an important part of this mainte-
nance. Regular cleaning and care will prolong the life of the seats and improve the general appearance.
Everyday dirt and soil - Most everyday soil and dirt may be removed with a soap and water solution. If
the stain is persistent, a stiff bristle brush may be used. Fabric covered seats should be rinsed with clean water
after stain is removed.
Paint, tar and asphalt
- Remove stain immediately using a damp cloth and kerosene. Rub the stain
gently, using small strokes. Rinse thoroughly. NOTE: This type of stain may become permanent if not cleaned
immediately.
Nail polish and lacquer-based stains - Soak up as much as possible with dry cloth immediately. Any
remaining stain may be removed with a nonflammable cleaning fluid such as “Tuff Stuff” or “Armorall”
cleanser. Rinse thoroughly with clean water.
Gum, grease and shoe polish - Remove as much as possible immediately. Shoe polish if left for any
length of time will permanently stain. Clean any remaining stain with “Tuff Stuff” or “Armorall” cleanser.
Ink - Remove stain immediately using a damp cloth and alcohol.
SEAT CUSHION REMOVAL & INSTALLATION - DOT SEATS
WARNING: If seat cushions are removed for maintenance, they must be reinstalled using the following
instructions. Failure to comply with these instructions could result in injury from unattached seat cush-
ions in the event of an accident.
REMOVAL
1. Loosen the two front swivel type clamps at the front underside of the cushion with a phillips-tip
screwdriver. Caution: Do not remove clamps.
2. Rotate the swivel clamps so as to clear the front retaining channel frame.
3. Lift the forward edge of cushion 2 to 3 inches and pull cushion forward to remove.