15
www.bitrek.com.ua
[email protected]
+380 44 507 02 07
Example of response: «Param ID #### New Val: #», where:
Param ID - ID of parameter to be set up;
New Val - assigned value of parameter.
Example of the command to set APN of the device (a parameter that contains
the APN device has ID 0242) - setparam 0242 gps.utel.ua;
Example of response: «Param ID 0242 New Val: gps.utel.ua».
Update of device software.
Command to be sent - BOOT #,#,#;
Example of command to update the software:
«
BOOT fw.bitrek.ua,80,*.bin
;»
, where:
«HOST» - (fw.bitrek.ua,) - address of server locating the update files;
«PORT» - (80,) - port of server locating the update files;
«Firmware» - (*.bin;) - binary update file,
where * - the firmware version, .bin - file extension.
This command allows remote software update of the device via GPRS channel.
Note: Enable "download" for the SIM-card, and set the session timeout not
less than 10 seconds.
There are following responses at attempt to update the device software:
«BOOT: UPDATE DOWNLOAD OK» - successful update;
«BOOT: WAITE ERROR» - exceeded timeout at downloading software update;
«BOOT: HOST CONNECT ERROR» - failure to connect to server with SW;
«BOOT: PAGE LOAD ERROR» - failure to load the file;
«BOOT: UPDATE DOWNLOAD ERROR» - failure to update the file.
Set the mode of operation of digital inputs Out 1 and Out 2.
Command to be sent -
setdigout #;
Example of command for the activation of the output Out 1:
setdigout 1;
When it is necessary to activate the output, set the output value must to "1".
When it is necessary to deactivate the output, set the value to "0".
Activate/deactivate the safety locking of ignition.
Command to activate safe locking -
ignitionon
;
Command to deactivate safe locking -
ignitionoff
;
In case of activation of secure locking the discrete output Out 1 will be
