10
www.bitrek.com.ua
[email protected]
+380 44 507 02 07
Connect the cable of USB-UART converter to the tracking device so that
the arrow on the cable socket was located closer to the SIM-card slot (see
Figure 4).
To work with the USB-UART converter, install the appropriate device
drivers.
They
can
be
downloaded
from
the
official
website:
To exchange data with the device, use a terminal program. Settings of
the terminal: speed - 115200 bit/second, data bit - 8, stop bit - 1, no parity
check, no flow control.
Once connected, the device will transmit data about its state to the
terminal. In addition, the user is able to use a terminal program to send
commands to a device and receive response to them. Send preliminary to
device the password to access the terminal in the following format:
TPASS: password;
, where password is a password for access to the device terminal
(default value is 11111).
Lifetime of access password after sending is 60 seconds.
After this time, re-send the password to exchange data with the device.
Description of indication elements
Top panel of the tracking device contains two LEDs that indicate the
current status of the device.
LED "STATUS" (red) is on for 0.5 seconds and is off for 0.5 seconds
when GPRS connection is inactive; is constantly on when GPRS connection is
active and the device is connected to a remote server; LED slowly flashes for
0.2 seconds when GPRS connection is not active, and the modem is in sleep
mode.
LED "GNSS" (green) flashes when the device is receiving correct
position coordinates and is off when the device is not receiving the
coordinates, or the signal is too weak, and the data are not correct.
Adjustment of "BI-520L TREK" device
Basic information
The tracking device "BI-520L TREK" can be configured in following
ways:
1.
With a direct connection of the device to a computer.
2.
Remotely, using SMS commands.
3.
Remotely, using the configuration server.
