9
www.bitrek.com.ua
[email protected]
+380 44 507 02 07
Carrying out welding work during the repair of the vehicle necessarily
requires disabling of power socket and peripherals.
Analog input voltage can range from 0 V to 27 V.
The discrete output of the device are made according to the scheme
such as "Open collector". The load shall be connected to the gap between the
discrete output and "+" power of the on-board network. When activated, the
output gets ground switching. Maximum current of the discrete output load
shall not exceed 0.5 A. If it is needed to switch higher currents, connect
digital outputs via additional relay.
Analogue input voltage shall not exceed 27 V.
Device supply voltage shall not exceed 36 V. Otherwise the device
may be put out of action
.
Device to computer connection
The tracking device can be connected to a PC, in order to configure the
device, as well as to perform maintenance works. For this purpose, the device
is equipped with a service UART output. To connect to a computer, use an
additional USB-UART converter, which can be purchased from a dealer for an
additional fee.
UART output socket is located on the board of the device next to the
SIM-card slot. To access the socket, remove the side cover of the device.
Procedure of connection of USB-UART converter cable is shown in Figure 4.
Figure 4 - Connection of the cable of USB-UART converter to the device "BI-
520L TREK".
