1-69
D70ES
9.4.15 General data request indicated with “n”
Xln<CR>
Using this command it is possible to read the current value of any one of the
general data (if you are in the relative mode).
9.4.16 "y" value setting request in the general data
identified by "n"
yXln<CR>
where "y" is the value you wish to give to general data "n". Obviously the
value that you wish to enter must be consistent with the data format.
It is not allowed to set values for some general data (e.g. pieces).
9.4.17 Net weight and scale status transmission request
Xn<CR>
(Xnb<CR>)
NOTE: The command that needs to be sent consists of an uppercase X and
a lowercase n (not to be confused with the generic meaning attributed to
lowercase n, explained in
par. 9.1 on page 1-61).
If positive, the terminal responds with the following string:
n<SP><um><SP><s1><s2><s3><s4><CR><LF>
Characters s1, s2, s3 and s4 are status characters whose meanings are
explained in
par. 9.4.8 on page 1-71
and n is a 9 character numerical field.
9.4.18 Net weight request in high resolution
YN<CR>
The response string is:
n<SP>y<SP><um><SP><s1><s2><s3><s4><CR><LF>
n = net weight (9 character numerical field)
y= net weight in high resolution (10 character numerical field)
s1,s2,s3,s4=see STATUS in extended string (
par. 9.2.2 on page 1-63).
