5
HTE402559
19/47
7.
Push “Set” button to shift the mode from
“Indication” to “Adjust”.
Blinkin
Push “SET” button
8.
Dial the Setting Encoder in the counterclockwise to reduce
the drive frequency so that the work pieces are discharged smoothly.
Push “Set” button two times to shift the blinking digit
from decimals to units.
Setting Encoder
Dial
9.
When the work pieces are discharged smoothly, push the “Save” button
to store the data having been set.
Push “Save” button
Storing
New data is stored
6.
Push “Run/Stop” button and run the partsfeeder or linear feeder.
This example shows the partsfeeder is running at the output
voltage 75 % and drive frequency 90 Hz.
Note: When RUN lamp is blinking
see
“Alarm by blinking RUN lamp” on the page 8.
5．
Dial “Selection Dial” and select “Frequency”.
Selection Dial
Turning on
Dial
Push Run/Stop
Turning RUN lamp on.
