5
HTE402559
16/47
After finished the setting of “Frequency Range”, please set the stroke
of the partsfeeder or linear feeder.
Put some work pieces in the bowl or chute and set the stroke so that they are
discharged smoothly on the track.
Please make sure:
a. Stroke sensor is connected.
b.
“Auto Freq”, indicating auto-tuning mode, lamp is turned on.
How to adjust the Stroke on the auto-tuning mode
1.
Dial the selection dial and select “Frequency” turning “Frequency” lamp on.
The maximum output frequency selected in the initial
setting appears on the display.
Check the former selection is correct or not.
Frequency Range
Value
45～90Ｈｚ
90～180Ｈｚ
180～360Ｈｚ
65～120Ｈｚ
Initial Setting
-Continued-
Selection Dial
Turning on
Dial
2. Push “RUN/STOP” button.
Then the partsfeeder is running and the output drive frequency chases the resonant frequency of the
drive unit. The drive frequency becomes close to the resonant frequency the auto-tuning is completed.
“Auto Freq” lamp is blinking during the tuning and turning on after it is completed.
Push
Auto Freq: Blinking
Auto Freq
Auto Freq:
Turning on
Auto Freq
How to adjust the Stroke on the auto-tuning mode
