Betafence Bekamatic SC 6000 Line, Руководство по установке

Страница: 26 / 28

[H ie
Bekamatic SC pg. 26
r eingeben] [H ier eingeben] [H ier eingeben]
14.2. Start the Self-Learning procedure
ATTENTION!
DURING SET UP ALL SAFETY DEVICES ARE DISABLED! THEREFORE,
ONLY CARRY OUT THE OPERATION WHEN NO TRAFFIC IS IN THE
WING MOVEMENT AREA.
If a system without an encoder is installed, mechanical stops are required for the
wings. We did the set-up for the Bus devices and the end positions are stated.
The gearbox is engaged.
At this point the self-learning process can be initiated, this is always started with
the gate in the closed position.
1) Enter BASIC programming (With F) and go to the parameter tL, when F
is released -- will appear.
2) Ensure that the gate wing(s) are closed. Otherwise, proceed as follows:
3) Press /R1 to close the gate.
Should by pressing /R1 the gate wing (s) open, switch off the power
and, on terminal board J2, invert the phase cables of the corresponding motor
(s) (terminals 2-3 for wing motor).
4) When the gate wing is closed, launch SETUP by pressing and h
and – until S1 begins to flash on the display (Approx. 3 secs).
5) R and -. The wing begins its opening movement.
6) Once installation and programming are completed, ensure that the
system is operating correctly.
7) Be especially careful that the safety devices operate correctly and
ensure that the system complies with all current safety regulations.
8) Close the cover in the provided seat with gasket.