Betafence Bekamatic SC 6000 Line, Руководство по установке

Страница: 17 / 28

[H ie
Bekamatic SC pg. 17
r eingeben] [H ier eingeben] [H ier eingeben]
5) Refit the safety pressure strip into the aluminum profile.
To aid this, spray some silicone lubricant onto the rubber
profile on the rear of the strip and push it into place.
9.2. Adjustment of the rear mechanical end
buffer:
The rear mechanical end buffer is an integral part of the rear roller
assembly and is adjustable in length up to 450mm maximum (Exception:
for gates up to 4000mm the adjustable length is up to 200mm
maximum). This is the maximum adjustment with allows a good
functioning of the gate under the applied forces. Therefore, we strongly
advise, always adhere to the dimensions laid down in the foundation
plans.
1) Remove the rear cover plate from the under beam
by unscrewing the 4 screws (2 on each side).
2) Close the gate so that there is 10mm to 20mm
between the upper guiding rollers on top of the
wing and the bottom of the catcher on the lock
post.
3) Loosen the counter nut. Turn the threaded rod anti-
clockwise so that the rubber stop protrudes out of
the under beam by 5mm to 10mm.
Re-tighten the counter nut.
4) Replace the cover plate to close the under beam and tighten the screws
with moderate force.