Betafence Bekamatic SC 6000 Line, Руководство по установке

Страница: 16 / 28

[H ie
Bekamatic SC pg. 16
r eingeben] [H ier eingeben] [H ier eingeben]
0°
< 90°
9. Adjustment of the mechanical end stops:
ATTENTION!
The verification and/or the adjustment of the mechanical end buffering
must always be carried out. When the end buffering is not adjusted
properly it may cause severe irreversible damage to some parts of the
gate.
The mechanical end buffering is located on the front and rear roller
assemblies found in the under beam. To gain access to them, the front
and rear end caps of the under beam must be removed.
9.1. Adjustment of the front mechanical end
buffering:
If the gate is installed correctly according to the foundation plan, then the
front buffer does not need to be adjusted as the factory default setting of
60mm will be sufficient.
However, if there is some deviation from the foundation plan,
or an obstacle at the rear side of the gate prevents the wing
opening over its full course, then adjust according to the
description below.
1) Pull the lower part of the safety pressure strip from its
aluminum fixation profile.
2) Remove the front cover plate from the under beam by
unscrewing the 4 screws (2 on each side).
3) Loosen the counter nut. Turn the
threaded rod anti-clockwise so that the rubber stop
protrudes out of the under beam by 5mm to 10mm.
Retighten the counter nut.
4) Replace the cover plate to close the under beam and tighten the screws
with moderate force.
Remarks:
It’s very important to fill the space under the plate of the Guiding and lock post
with shrinkage-compensated concrete.