bergmann ALPHA-PACK-BIN, Руководство по эксплуатации

Страница: 11 / 98

3. Principle safety considerations
3.
03
* It is not allowed to make any modifications, extensions or reconstructions on the machine without the
prior written consent of BERGMANN. This is also valid for welding works at load bearing parts.
* If the machine is combined with other machines (e.g. conveyor belts, etc.), a separate risk
assessment has to be created by the operator.
* The pressure in the hydraulic system may only be changed by an authorised expert of BERGMANN.
* It is not allowed to make changes on sealed components. This applies especially for hydraulic
valves.
* During the operation, all noise protection devices (aggregate doors, aggregate hoods, etc.) must be
closed.
* The type of material compacted can result in different noises. The decibel value indicated was
measured on an empty machine.
* To minimise noise emission, we recommend a cover hood.
* The substances and materials used must be used and disposed of properly.
* Toxic, explosive and chemical materials may not be compacted and must be disposed according to
the local regulations.
* It is the owner/user's responsibility to provide the operating personnel with special protective
equipment (e.g. protective clothing, goggles, gloves, etc.) for medical waste. For this use, we
recommend equipping the machine with a hood and covers, which must be closed prior to
compaction.
* Fill in compactable material only. Otherwise steel girders, timber planks etc. might damage the door.
* Smaller hard material (screws, glass etc.) and hardening materials as well as materials which are
subject to special regulations according to the law concerning waste disposal must not be compacted.
* It is not allowed to press materials that may incur the risk of hauling out (hard plastic, splintering
wooden parts). If hauling off of smaller parts cannot be fully excluded, the filling opening must be
closed with a special covering hood during the pressing process. The hood must be approved by
the manufacturer for this use.
* On the plastic versions small metal parts may accumulate and cause noise.
They must be immediately repaired by an authorised expert.
* Use a rubber sheathed cable type H07 RN-F with a minimum cross section of 2.5 mm² for the
power supply.
* An earth leakage circuit breaker with 30 mA should be provided by the customer.
* Pressure receptacles, like hair spray cans, spray cans, etc. may not be compacted. Risk of explosion.
* The container must not be overfilled.
3.2.2 Safety and protective devices
* It is prohibited to enter and to reach into the compaction chamber.
* Prior to switching on make sure that there is nobody in the compaction chamber resp. in the
container.
* It is not allowed to remove or change any safety devices. The safety devices must be fully-
functioning.
* In case of malfunctions, the machine must immediately be shut off and the fault must be eliminated
by an expert with the corresponding knowledge.
* Machine parts which are not in a perfect condition must be replaced immediately.
* In consideration of the safety distances (see point 3.3 “Safety distances”) the use of ramps and
platforms is allowed.
* If the machine is filled via ramps, platforms, etc., the owner/user must create a separate risk
assessment.