Bentone B 45i A2.2H J/K, Инструкция по установке и обслуживанию

Страница: 65 / 108

65
Bentone
Display: Value 0
Press
/reset
to backup process.
Press to shift the value in change mode 1 position to the left.
Display: Value 1 flashes
Press
/reset
to activate the backup process.
Display : 1 appears
After about 5 seconds (depending on the duration of the program), 0
appears on the display, indicating the end of the backup process.
Display: 0
! If an errror occurs during the backup
process, a negativ value is displayed. For
error diagnostics, the cause of the error can
be determined from the diagnostic code of
error message 137 (see Error code list)
Press
ESC
four times until the top menu is displayed.
! Note! The value must
be set to 1 if a backup
is required, and to 0 if a
backup is not required.
The values higher than 1
which can be set must not
be used.