Bentone B 45i A2.2H J/K, Инструкция по установке и обслуживанию

Страница: 33 / 108

33
Bentone
7.1.4 Replacing the solenoid valve (pump)
1. Switch off the main power supply and disconnect the Euro plugs from
the burner.
1. Disconnect power cables to solenoid valves.
2. Loosen nut holding the solenoid coil.
3. Loosen screws that secures the valve mounting plate.
4. Remove valve.
5. Check that it is the correct valve. NO
6. Install the new valve and refi t the other parts in the reverse order.
7. Check functionality.
7.1.5 Replacing the gasket seal (pump)
1. Disconnect hoses, oil lines, and electrical cables.
2. Loosen pump (screw J).
3. Loosen locking rings for gasket seal.
4. Remove the old gasket seal (2).
5. Install the new gasket seal.
6. Connect hoses, oil lines, and electrical cables.
7. Test run and check seals.
Components Oil pump
1. Pressure regulator
2. Shaft seal kit (lip seal + protective cone)
3. By-pass plug
4. G 1/4 gasket
5. G 1/4 steel plug (1-pipe system)
6. Filter
7. Cover gasket
8. Cover
9. Pressure gauge port or vacuum
gauge port screw, O-ring
10. Coil
11. Tube assy
!
Before obtaining access to terminals,
all supply circuits must be disconnected.
1
2
3
4
5
6
7
8
9
10
11