Bentel academy 40, Руководство по установке

Страница: 41 / 80

Dialler
Up to 32 Dialler actions can be programmed. The programmed actions can be assigned to the events in the
Event-Actions
page. Each Dialler action will send a Voice message to signal the start / end of the corresponding
event. Refer to
Dialler
in the
APPLICATIONS
chapter for further details on Dialler programming.
Each telephone dialler action can send one of the 14 Voice Messages to up to 16 telephone numbers (selected
from the 32 programmable numbers available).
n Dialler Telephone Numbers
The assigned voice messages will be sent to the Dialler Telephone numbers when the programmed events occur.
Program the telephone number parameters on the left side of the
Dialler
page.
no.
This is the non-modifiable identifier number (1 through 16).
Tel. Num.
Enter the identifier number (1 through 32) of the required telephone number (refer to the
Telephone
page) that the
voice message must be sent to. The telephone number label will appear automatically in the
Description
column.
+
It is not necessary to follow the order defined in the
Telephone
page, however, dialling priority will be defined by
the order established in the table.
+
The
Description
column can be changed in the
Telephone
page.
Repetition time
Enter the total number of seconds that the Voice message must run. A different
Repetition time
can be specified
for each telephone number.
Replay pause
Enter the number of seconds between voice message replays.
Voice timeout
Enter the number of seconds the Panel must wait for a voice answer before hooking up. This parameter depends
on the
Send message after
option, as follows.
Ø Voice on line:
the Panel will hook up after dialling----if a voice answer is not detected within the programmed
Voice on line
time.
Ø
First ring:
the Panel will hook up after dialling----if a back-ring is not detected within the programmed
Voice on
line
time.
Ø Dial:
the Panel will send the message immediately after dialling the number.
Attempts
Enter the number of tries the Panel must make in the event of an failed call.
Call successful
numbers
If this option is enabled the telephone numbers of successful calls will be redialled in the following cycles. If not,
the successful numbers will be bypassed in the successive cycles.
The programmed parameters of the
Replay pause
,
Voice timeout, Attempts
and the
Call successful numbers
options will be the same for all Telephone numbers.
Figure 27
Dialler page
PROGRAMMING 41