INSTALLATION
Installation steps
The Panel must be located in a safe place.
IMPORTANT
The Panel must be at least 2 metres from GSM and radio relay systems.
Step 1
Create a layout----include all alarm detection devices, zone expanders, keypads, key readers, etc.
Step 2
Drill the holes
for the cabinet
3
and snatch bracket
14
(see figure 2----
"Parts"
).
Step 3
Pull the connection wires through the hole
11
(see figure 2----
"Parts"
) then attach the cabinet and snatch bracket
to the wall.
+
Do not over tighten the snatch bracket screw as this may damage the bracket.
Step 4
Install the additional modules and boards (Omnia4IN, Omnia4OUT, OmniaVOX, etc.----refer to the relevant instruc-
tions).
Step 5
Make all connections----do not connect the Mains until all other wiring is complete.
Mounting the
keypad
The keypad should be located in a place where full control of the security system is required.
Step 1
Remove the screws
30
and the keypad box.
Step 2
Unplug the buzzer
(plug
45
).
Step 3
Remove the PCB----lift the plastic board support clips
35
.
Step 4
Drill the holes for the cabinet and snatch bracket screws (
42
and
43
).
Step 5
Pull the connection wire through the hole
41
then attach the cabinet and snatch bracket to the wall.
Step 6
Replace the PCB and plug the buzzer in (plug
45
).
Step 7
Assign the keypad identifier number----use the dipswitches
39
----complete the connections on the terminal board
34
then close the keypad box.
41
34
30
30
45
35 42
43
42 35
39
Figure 9
Keypad mounting
INSTALLATION
17
Содержание academy 40
Страница 1: ...INSTALLATION MANUAL BS EN ISO 9001...
