BendPak Autostacker PL-6SR, Инструкция по установке и эксплуатации, Страница: 18 / 104

Autostacker™ Parking Lift
18
P/N 5900002 — Rev. D — August 2019
To add Chalk Line Guides
:
1. Decide where you want to place the Autostacker.
2. Create an Alignment Chalk Line where you want the front of the Autostacker.
Make the Alignment Chalk Line
longer than the Total Width setting for the Autostacker.
3. Create two perpendicular chalk lines at 90° angles to the Alignment Chalk Line.
Make the distance between the Left Side Chalk Line and the Right Side Chalk Line the distance of
the Total Width setting for the Autostacker, found in Specifications .
For a
Multi-Lift
setup, see Multi-Autostacker for modified specifications. If you plan to
position the Control Stand at the
Rear
of the Lift, use the Total Width (A); do not use the A1 figure.
4. When you want to move the components into position, put the Bottom Connector Tube against
the Alignment Chalk Line and between the Left and Right Side Chalk Lines.
Put the Leg Assemblies up against the Bottom Connector Tube and inside the Left and Right Side
Chalk Lines, respectively.
The Leg Assemblies are
not interchangeable; the Door Sentry car-door protectors go on the
inside.