Belarus 1523, Руководство по эксплуатации

Страница: 39 / 312

BELARUS- 1523/1523В /1523.3 /1523В.3 Drive Controls and Instrumentation
38
CI programming procedure
1. On selecting the fixed value of the programming parameter:
1.1. On pressing the “Parameter” (Параметр) button for the first time, the LCD is
switched to the mode of viewing the parameter to be programmed and its numerical
value. On pressing this button repeatedly, the parameters are switched over cyclically.
1.2. On pressing successively the “Value” ( Значение ) button, the numerical value of the
set parameter to be programmed changes.
1.3. The mode is exited automatically if neither “Parameter” (Параметр) nor “Value”
(Значение) button has been pressed within 7.0 sec.
On exiting the mode, the last values of the parameters selected by the “Value”
(Значение) button are saved .
2. When entering the unfixed value of the programming parameter:
2.1. Select the parameter, the values of which shall be set, by means of the “Parameter”
(Параметр) button;
2.2. Press twice the “Mode” (Режим) button; the least digit of the numerical value starts
blinking;
2.3. To change the value of the blinking digit of the parameter, use the “Value”
(Значение) button ;
2.4. To go to the more significant digit, press the “Parameter” (Параметр) button;
2.5. To exit the mode of programming an unfixed value of any parameter, press twice
the “Mode” (Режим) button ;
2.6. On exiting the above mode, the digits of the entered value of the parameter be-
come lit steadily;
2.7. The newly entered value is set the last in the list of the parameter values allowed to
be programmed;
Note:
- If the “Mode” (Режим) bu tton is pressed once in the programming mode, it is
impossible to enter an arbitrary value of the parameter;
- Should none of the buttons “Mode” ( Режим ), “Parameter” (Параметр) , “Value”
( Значение ) be pressed within seven seconds in the mode of entering the unfixed value,
the CI will be switched automatically to the basic LCD operation mode with saving the
set values of the parameters.
It is allowed to enter one unfixed value within the range:
for “ Z ”: from 23 to 69;
for “ I ”: from 1.000 to 4.000;
for “ R ”: from 400 to 1000;
for “ K ”: from 2.360 to 4.000 (for a CI without CAN-interface)
for “ KV2 ”: from 0.346 to 0.600;
for “ ZV”: from 12 to 78;
for “ V ”: from 0 to 600.