Belarus 1523, Руководство по эксплуатации

Страница: 188 / 312

BELARUS- 1523/1523В /1523.3 /1523В.3 Подготовка трактора к работе
177
GETTING THE TRACTOR MOVING AND DRIVING THE TRACTOR
Belarus 1523/1523 В ( КП 16F+8R)
To bring the tractor in motion, proceed as
follows:
• slow down the engine;
• step on the clutch pedal as far as it will
go and select a required GB speed
range; to do this:
• move the lever (1) to its rightmost
(spring-loaded) position and pull or
push it to select the I (lowest) or II
(highest) speed range, respectively;
• return the lever to the neutral (“N”)
position and further move it to the
left to choose the required speed in
accordance with shift pattern dia-
gram I;
• choose the required gear by means
of the lever (2) in accordance with
shift pattern diagram II;
•
release the parking brake and ease
up the clutch pedal smoothly while
increasing simultaneously the en-
gine rotational speed. The tractor
will start to move.
IMPORTANT! To shift in the gear
smoothly (without abrupt jerks), move
the gear-shift lever (2) in accordance
with diagram II and hold it in this posi-
tion with slight pressure until the gear
is in full mesh.
ATTENTION! Prior to setting the re-
quired speed range or to shifting in the
gear in the GB, make sure that you
have stepped on the clutch pedal.
IMPORTANT! To avoid noisy change-
over, shift the range select lever (1) when
the tractor is at complete standstill only.
When driving the tractor, DO NOT keep
your foot on the clutch pedal, since this
would cause clutch slippage, its over-
heating and failure.