Service Instructions Automatic Single-Head Serging Machine 1265-4
Beisler GmbH
C-6
C.3
Start-up
C.3.1 Aligning the machine table
After the machine has been installed at the desired location, the machi-
ne table must be aligned:
Set machine table to required height.
Level machine table horizontally on all sides.
Setting the table height:
1.
Fig. 1:
Lift machine: Connect lifting device at lift points (arrows) be-
low the crossmembers. If the machine is equipped with the optional
transport rollers, release brakes before lifting.
2. Loosen locating screws
2
on all table legs.
3. Pull table legs
4
out to the desired length and retighten locating
screws.
4. Tighten height adjustment locating screws
2
.
5. Lower machine onto floor.
6. Level worktable horizontally in all directions.
7. Tighten height adjustment locating screws
2
.
NOTE - Shipping braces
Before the machine is connected to the power supply sy-
stem and operated, all shipping braces must be removed.
Cut off cable ties.
Remove labels.
Remove protective film from operating panel.
C.3.2 Compressed-air connections
Fig. 2:
The compressed-air connection is preinstal-
led on the machine. It comprises the following com-
ponents:
Pressure reducer
2
with manometer
4
and
water separator
5
,
Pressure hose with push-in plug
3
.
The pressure reducer ist installed to the machine
frame.
Connecting the machine to the compressed-air
supply system:
1. Connect pressure hose plug to on-site terminal
unit.
2. Open on-site compressed-air supply.
3. Set pressure reducer to a machine operating
pressure of 6 bar by rotating pressure reducer
knob
1
and read value on manometer
4
:
To increase pressure, rotate in the clockwise direction.
To reduce pressure, rotate in the counterclockwise direction.
Fig. 1
Fig. 2
