Service Instructions Automatic Single-Head Serging Machine 1265-4
Beisler GmbH
C-20
Abb. 11
C.5
Maintenance
C.5.13 Inserting the bonding strip at the bonding station
Fig. 11:
The bonding strip rolls off a drum. The sepa-
rator removes the strip from the backing tape and pu-
shes it over the lower stamp
1
of the heating modu-
le. To insert the bonding strip:
1. Remove the disk
8
from the drum; the disk is
merely pushed on.
2. Attach the bonding strip roll
9
to the drum and
push the disk back onto the drum.
3. Rotate the pressure pad
5
of the guide
4
side-
ways.
4. Separate the bonding strip from the backing tape
6
and route the strip through the slot
3
.
5. Rotate the pressure pad back onto the guide and
cut the bonding strip at the edge
2
of the guide.
NOTE - Position of the lower stamp
The proper function of the bonding unit
is only ensured if the lower stamp is in
the lowered position. By actuating the
switch
5
, the lower stamp can be mo-
ved to the upper or lower position.
For cleaning, the lower stamp is moved
to the upper position, and the bonding
station heating module is switched off.
