BEFCO DR0-308, Руководство оператора

Страница: 15 / 52

4. Attach the driveline chains to the tractor and to the windrower rake to keep the
driveline protection from turning. The chains should not be too tight.
5. Ensure the driveline has at least 2” from bottoming out in its shortest working
position and has the minimum 6” overlap in its longest working position. Refer to
Section 4.09
6
of this manual, if it is determined that the driveline is too long and
needs to be shortened. Contact your local dealer if it is determined that the driveline
is too short for your tractor.
6. Raise all support stands and secure them with lock pins.
On pull type windrower model DRP-308 always make sure to adjust the tractor drawbar
as specified to ASAE standards to prevent failures
(see fig. 5) . An improperly set hitch
could subject the driveline’s universal joints to undue stress.
The drawbar should be centered under the PTO shaft and secured so it cannot swing in
either direction.
CAUTION: Failure to conform to ASAE standards for drawbar PTO setup
dimensions can result in driveline damage and implement failure.
3.06 - Start Up
DANGER: The windrower rake must always be lowered to the ground before
starting tractor engine or engaging PTO lever.
Lower windrower rake to the ground. Lock the tractor rock shaft control lever in this
position. With the engine idling, slowly engage the PTO drive. Move the throttle lever
O
PERATION
15
BEFCO
W
INDROWER
R
AKES
O
PERATOR
’
S
M
ANUAL
6
See Section 4.03 - Driveline, for instructions on how to determine correct driveline length and
procedures for shortening the driveline.
Fig. 5 - Drawbar adjustment
14" for 540 rpm
6" to 12"
13" to 20" from ground
1"
min.