BEFCO DR0-308, Руководство оператора

Страница: 23 / 52

13. Unauthorized modifications to the machine may impair the function and/or safety of
the machine and reduce its life. If equipment has been altered in any way from
original design, the manufacturer does not accept any liability for injury or warranty.
4.02 - Service
The accompanying illustrations show lubrication points. The chart gives the frequency of
lubrication in hours, based on normal operating conditions. Severe or unusual
conditions may require more frequent lubrication.
Use a good quality SAE multipurpose type grease for all locations shown. Be sure to
clean fittings thoroughly before using grease gun.
Use 90 wt. or 140 wt. gear oil in gearbox.
Important: Check hardware tightness on the tines after the first two, five and ten hours
of operation. As these components set in with use, the attaching bolts may loosen.
Hourly or whenever an obstacle is hit:
Check the conditions of the tines, joints, rotors and gearboxes.
Every 8 hours:
1. Lubricate driveline:
Apply two or three shots of grease to the driveline cross and
bearings and the telescoping shafts. See the driveline manufacturer operator’s
manual for further information on the driveline.
2. Check hardware tightness; windrower rake vibration can loosen bolts
8
.
3. Lubricate threaded rod on height adjustment lever.
4. Check gearbox oil level (see fig. 11): It should be just below the oil plug on the
side of the gearbox. If needed add either SAE 90 wt. or SAE 140 wt. gear oil.
Every 25 hours:
1. Lubricate wheel spindles.
2. Lubricate grease fittings in the height adjustment lever, the upper gearbox cover and
the wheel axle.
3. Lubricate joints in tine arms.
4. Check tire pressure. If necessary inflate tires to 25 PSI.
M
AINTENANCE
23
BEFCO
W
INDROWER
R
AKES
O
PERATOR
’
S
M
ANUAL
8
See Table 1, page 26.
Fig. 11 - Gearbox
Oil plug. Fill gearbox with oil until
it reaches the level of the plug
Drain plug