BEFCO DR0-308, Руководство оператора

Страница: 14 / 52

DANGER: Stay clear of rotating driveline. Entanglement in rotating driveline can
cause serious injury. Disengage PTO, engage parking brake or place
transmission in “Park”, shut off the tractor and remove the key before
working
around hitch, attaching or detaching driveline, making adjustments, servicing or
cleaning the machine.
3.05 - Attaching to the Tractor
Only use this model implement with tractors in the correct power range
5
. Never use this
windrower rake with tractors over 50 HP.
CAUTION: Check the tractor PTO rpm to ensure it is set at 540 and turns
clockwise.
CAUTION: Never attempt to attach the windrower rake to the tractor or make any
adjustments to it without first turning the tractor off.
DANGER: Failure to ensure a secure coupling of the implement to the tractor can
cause injury and damage to the implement or tractor.
If necessary, wheel weights,
front tractor weights and/or tire ballast should be used to improve stability. Be
sure that the tractor tire pressure is correct. It is important to strictly follow the
safety guidelines and instructions laid out in the tractor’s operator’s manual.
To attach the windrower rake to the tractor do the following:
1. On windrower rake model DR0-308, back the tractor up to the rake in order to attach
the tractor hitch arms to the hitch pins on the rake. Turn off the tractor engine.
Secure them in place with the lynch pins. Adjust the tractor sway blocks or chains to
remove all side movement. Attach the top link.
2. On windrower rake model DRP-308, position the tractor drawbar (see fig. 5) .
Remove the hitch pin. Back up the tractor to the rake. Align hitch pin holes in tractor
drawbar and windrower rake.
Turn off the tractor engine. Install hitch pin and
fasten it with a lynch pin.
3. Install the shielded driveline to the tractor by first lining up the splines and
depressing the snap pin. Push the yoke onto the PTO shaft as far as it will go.
Release the pin and pull back slowly until the pin clicks in place. Repeat this
operation on the implement end. Be sure to install the overrunning clutch side of the
PTO shaft on the implement.
O
PERATION
14
BEFCO
W
INDROWER
R
AKES
O
PERATOR
’
S
M
ANUAL
5
See Table 2, page 26.