IMPORTANT INSTRUCTIONS
BEDJET USER OPERATING MANUAL
Revision 1.0
www.bedjet.com
P a g e | 16
12) Familiarize yourself with turning on and off the various operating modes while the
Status Display of BedJet is visible before the BedJet is pushed under the Bed.
13) The ideal BedJet final installation location is under the bed.
This product is designed to be an extension of your bed and
has been electrically approved as safe for this installation.
The BedJet requires 7 inches clearance and will fit under
nearly all beds with standard height bedframes. Some
bedframes with low hanging side rails may look like they
cannot fit the BedJet underneath, but may just be the side
rail and the under mattress area may still have 7 inches
height clearance. In these cases, the bed frame may be
lifted up and the BedJet placed underneath. As long as the
mattress or frame does not rest on the BedJet and the hose
can clear the low side rail, the installation is acceptable.
SPECIAL NOTE FOR POWERED ARTICULATED BED FRAMES:
The BedJet will work fine underneath adjustable bed frames,
provided care is taken to make sure that the BedJet and Air
Hose are installed in a location where the full range of frame
articulation will not crush either component. This may
require fully extending the Air Hose to move BedJet further away from the Air
Nozzle/Mattress mount location than shown here.
14) When installing under the bed, adjust the location of the BedJet exhaust port to be as
close as possible to the Air Nozzle. Best location is for the exhaust port to be directly
under the Air Nozzle so that it can be reached with only a single 90 degree bend in hose.
The best setup will minimize the length of Air Hose and minimize the number of bends.
Compress excess length in the Air Hose so that only the shortest length needed is used.
Compress the hose length not needed nearest the BedJet exhaust, and leave the hose
completely expanded going to the Air Nozzle. Straighten the Air Hose as much as
possible for the most efficient operation.
15) If the BedJet cannot be located under the Bed, locate it against the base of the bed, out
of the way from normal walk paths.
