IMPORTANT INSTRUCTIONS
BEDJET USER OPERATING MANUAL
Revision 1.0
www.bedjet.com
P a g e | 11
BedJet Operating Modes:
The BedJet main power switch (under the power cord) must be turned ON for the remote
control to function. Once the power switch is ON, the BedJet will beep once to indicate
successful boot-up of the internal microcontroller. The BedJet is now in standby mode.
Activate the BedJet by pressing the desired cooling/heating mode button on
the remote once. A single beep confirms an ON command.
Deactivate BedJet into standby by pressing the same mode button again. A
double beep confirms a mode OFF command.
While active in any given cooling/heating mode, pressing a different mode
button will switch cooling/heating modes without shutoff of the BedJet. The
BedJet will beep once to indicate the mode change. When changing from heating to cooling
mode it will take some number of minutes for the air exhaust temperature to become cool.
Adjust the Air Flow using the “+” or “-“ buttons on the remote to
increase or decrease the heating/cooling power to the bed. The BedJet
will beep once for each increase/decrease, which 5% of allowable Air
Flow range for each mode. Thus pressing 20 times gets you from full power to lowest power
for any given mode. Press and hold the buttons for rapid increase or decrease.
Press the Auto-Shutoff Timer Advance button to increase the time left on the
Audo-Shutoff function above the default time settings (see table below).
Press the Mute button on remote control to silence all beeps. Press again to
reactivate beep acknowledgement of remote commands.
Turbo-Heat Mode:
This mode is best used as a pre-heater for warming your bed quickly before getting into bed, or
for single short bursts while in bed. Turbo-Heat pumps the maximum amount of safe heat into
the bed with the maximum amount of airflow and can warm the temperature of your bedding
by up to 30 °F (17°C) above ambient in just five minutes.
This mode has a very short Auto-
Shutoff time,
as the warmth generated and noise levels are too powerful for extended use or
comfortable sleeping. See table below for operating parameters.
Do not continuously re-cycle the BedJet into Turbo-Heat mode while in the bed. If you
recycle BedJet in Turbo-Heat more than 15 minutes, the BedJet will beep 4 times to
remind you that instructions are not being correctly followed.
Do not place body parts directly into or in front of Air Nozzle in Turbo-Heat mode
