Commissioning
EL6201
113
Version: 2.2
Fig. 148: Configuration tree in the TwinCAT System Manager
Manual addressing of the AS-i slave
Note
AS-i address
The address of a brand new AS-i slave is always "0".
The addressing of a brand new AS-i slave can be done using the TwinCAT System Manager. The
installation of the
AS-i System Manager Extension
is required for this.
• Click on the EL6201 in the TwinCAT tree (A) and the “Settings” tab (B). Then click on "AS-i System
Overview" (C) to navigate to the AS-i overview below, which shows the AS-i slaves to be addressed.
• The "AS-i Config Mode" (D) field in the status bar is shown in blue. If a green field “ASI Protected
Mode” is displayed here, click on the field to access the “ASI Config Mode”
Note
Status Bar
The status bar in the system overview indicates the system state. Underlined settings can
be changed (switch between config mode/protected mode, activation/deactivation of data
exchange).
• The slave “0” (E) marked with the yellow dot is the connected slave that has already been detected and
which is to be given a valid address
