Bayer HealthCare Clinitek 500, Руководство по эксплуатации

Страница: 65 / 82

Revised 5/01
8.5
SYMPTOM POSSIBLE CAUSE REMEDY
Push bar does not 1. The last strip has been placed in a 1. The instrument is functioning properly. Begin a
move back to the left 1. loadlisted run, or the instrument is 1. new loadlisted run (after the current run is com-
after moving a strip. 1. waiting for entry of an ID. 1. plete) or enter the ID number being requested.
2. A very dark urine is being tested; 2. Presence of the strip will be verified at the first
2. the strip sensor is unable to verify 2. readhead, requiring an additional 3 cycles (21
2. the presence of the strip until it 2. seconds). The push bar should then move back to
2. reaches the first readhead. 2. the left. Continue testing in the normal manner.
Push bar moves to 1. The strip sensor was accidentally 1. The push bar will move back to the left after
the right when it 1. triggered by a hand, sleeve, or 1. 3 cycles (21 seconds); continue testing in the
shouldn’t (a strip 1. other foreign object. 1. normal manner. Be sure you do not place your
has not been placed 1. hand or other objects on the platform, as these
on the platform). 1. can be mistaken for a Reagent Strip.
2. Strip sensor problem. 2. From the Ready/Run screen (with the run completed
and the strip loading station clear of all strips and
foreign objects), turn the instrument power
off, wait
several seconds, then turn it back on to recalibrate
the strip sensor. If the problem continues, contact
your Bayer Customer Service office.
Test results are not 1. Internal printer is set to OFF. 1. Set the internal printer to ON through the Setup
being printed by the 1. Routine (see Section 3, Step A-4).
internal printer. 2. No paper installed in printer. 2. Install a new roll of paper as instructed in Section 5,
“Changing the Paper.”
3. Paper is misfed (accompanied by 3. Open the printer cover and check the paper path.
3. an unusual noise). 3. Reinstall if necessary (see Section 5, “Changing the
3. Paper”).
4. Loose electrical connection to the 4. Carefully remove and reinstall the interface cable
3. printer. 3. to the printer (see Section 7, “Printer Replacement,”
Steps 4 and 5).
5. Defective printer. 5. Run the Printer test (see Section 3, Step J-2f).
Contact your Bayer Customer Service office if it
doesn’t print correctly.
Touch screen does 1. Screen needs to be recalibrated. 1. Recalibrate as instructed in Section 7, “Calibrating
not respond correctly. 1. the Touch Screen.”
2. Defective screen. 2. Contact your Bayer Customer Service office.
63032-Section 8 11/8/06 9:51 AM Page 5