Bayer HealthCare Clinitek 500, Руководство по эксплуатации

Страница: 16 / 82

2.2
Revised 9/99
2. The remaining items shown in Figure 2-1 are packed
in the Installation Pack and shipped in a separate con-
tainer from the instrument:
2.
‹ &£
Operating manual: Binder and manual pages
(Manual pages may be supplied separately by your Bayer rep-
resentative. Depending on the language of the operating
manual you have received, there may also be a Warranty
Registration Card and/or a Customer Information Card.)
2. ‹ *£ Power cord
2. Make sure all these items have been included with
your instrument, and keep them for future use.
3. After the instrument has been unpacked, place it on a
firm, level work surface in the designated work area.
The instrument should
appear level, both side to side
and front to back. The back and sides of the instru-
ment should be at least 3 inches from an adjacent wall
or instrument.
3. NOTE: Retain the CLINITEK 500 shipping carton and
packing for at least several weeks. If the instrument
ever needs to be shipped, the shipping carton will
afford the best protection against damage.
4. Locate the piece of foam packing that is under the read
area cover. Gently pull down and forward on the foam
to remove it (Figure 2-2).
4. IMPORTANT: Be sure to remove the foam before
continuing!
Figure 2-2
5. If you have not already done so, insert the pages of
your Operating Manual into the binder.
Instrument Setup
1. Ensure that the instrument power switch is in the OFF
(“
● ●
”) position. Then plug the instrument line cord
into the instrument and into an appropriate ground-
ed AC electrical outlet.
2. Locate the bar-coded serial number, which is found
inside the instrument near the front left corner (Figure
2-3). Write the installation date and serial number in
the spaces provided in the “Preservice Checklist” in
Section 8 and on the Manufacturer’s Warranty Page
that is found at the end of this manual (contact your
Bayer representative for your warranty information if
this page is not included in your manual).
Figure 2-3
3. If a Warranty Registration Card is found at the front
of your manual, write the installation date and instru-
ment serial number on this card. After the instrument
has been successfully installed, completely fill out the
Warranty Registration Card and mail.
INSTALLATION
63032-Section 2 11/8/06 2:37 PM Page 2