Battenfeld UNILOG B2, Руководство по эксплуатации

Страница: 115 / 126

Maintenance
A: R82GB0HA.PMD
B: R82DE0HA.PMD
E: 080403 / T.Wenger
G: 020403 / TCS
Section 7
Page 13
7.8 Maintenance catalogue
The maintenance items listed below are
recommended. It is important to observe and
adhere to the specific maintenance rules
relating to individual components and modules.
Maintenance intervals, which are based upon
machine operation, are specified in operating
hours. The number of operating hours can be
read off the UHD and the counter zeroed.
The operating hours can be estimated using the
comparison table. The maintenance intervals
assume that each of the axes was running for
40% of the total operating hours (ED 40%).
If any major deviations occur, appropriate
changes must be made. Non-operation-based
testing and maintenance procedures must be
specified as follows:
d = daily
w = weekly
m = monthly
a = annually
If testing and maintenance procedures are
necessary at longer intervals than stated, this is
indicated by a prefixed number, e.g., 6 m =
every 6 months.
200 300 500 1000 1500 12000 24000
Constant operation approx. 500 to 1000
Single shift operation approx. 2000 1m, 1w 1m, 3w 3m 6m 9m 6a 12a
Single shift operation aprrox. 4000 2w 4w 1m, 2w 3m 3a 3a 6a
Single shift operation approx. 6000 2w 2w 1m 2m 3m 2a 4a
Constant operation approx. 8500 1w 2w 3w 1m, 2w 2m 1a, 4m 2a, 8m
R8B2_GB125.XLS
Operating hours comparison table
Operating hours/Maintenance cycles [h]
Operating mode
Operating
hours/year [h]