Battenfeld UNILOG B2, Руководство по эксплуатации

Страница: 100 / 126

A: R82GB0GA.PMD
B: R82DE0GA.PMD
E: 080403 / T.Wenger
G: 020403 / TCS
Section 6
Page 8
Operation
0
6.5 Automatic mode
Once the Automatic program has been
adequately tested in Single step mode, you can
start the token program for Fully Automatic
operation.
Automatic mode must be started outside of the
danger zones. (e.g. in the mould area)
Press the AUTO/SINGLE button.
Activate the START button.
Press the TOTMANN button
and the
START button to start the program
sequence.
The program sequence automatically runs to
the end of the program or until it is interrupted by
the user.
Status displays:
The status displays are used in the same way
as in Single step mode. (refer to 6.4)
Automatic mode speeds
In Automatic mode the linear axes are operated
according to the Override function setting (5% -
100%).
The override function
is adjusted in 5%
increments (Minimum
value = 5%, Maximum value = 100%) using the
two buttons (snail, hare) to the left and right of
the arrow buttons.
Override values can also be entered using the
numerical pad on the Axis status page.
(Minimum value = 5%, Maximum value = 100%).
Exiting Automatic mode:
Press the MAN button to switch to
Manual mode.
Press the AUTO/SINGLE button to
switch to Single step mode. (refer to
5.5.5 Creating token programs).