- 50 -
Problem
Cause
Solution
18. Water tastes salty.
Too short time of brine
treatment or too fast rinsing.
Change the programming,
set the correct time of brine
treatment and rinse (see
page 31).
Air inside the device.
The
air may get there during
the suction up process.
Call for service
Outflow of water during the
water treatment.
The brine
enters the resin tank but is
not rinsed out.
Press and hold the regene-
ration button to manually start
the treatment. This should
enable correct treatment.
Clogged sewer drain or too
narrow sewer drain hose
Clean the sewer drain and the
injection valve feed.
Decrease of the water
pressure or insufficient
amount of water during the
treatment.
Press and hold the regene-
ration button to manually start
the treatment. This will start
the regeneration process
again.
19. After treatment,
water flows out of
the sewer drain or
brine system.
Foreign particles in the
valve which prevent closing
of the valve.
Clean the valve, remove
foreign particles from the
valve.
Water pressure too high, the
valve cannot be set in the
appropriate position.
Reduce the water pressure.