Bartscher 296630, Инструкция по установке, эксплуатации и обслуживанию

Страница: 21 / 124

3
ENGLISH
GB
3. SAFETY
Read carefully the guidelines and
instructions in the instruction manual
before you use the appliance.
The
instruction manual contains general
information on how to safely use and maintain the
appliance. Retain the manual for future reference.
Electric installation conforms to CEI EN
60335-1 and 60335-2-37 regulation.
To prevent any hazard, the damaged
mains power cable may be replaced by the
manufacturer or service personnel only.
The manufacturer took extra care when designing
and manufacturing to prevent any safety or health
hazard to the personnel operating the appliance.
Please read carefully the guidelines in the
instruction manual and instructions placed directly
onto the appliance. Above all, observe all the
safety instructions.
Do not intervene in or remove the protective
devices
installed in the appliance. Non-
compliance may lead to severe safety and health
hazard against people. We recommend to perform
a few tests to know the layout and main functions
of the control panel, particularly those to switch
the appliance on and off.
The appliance is intended only for the use it has
been designed for and any other use is
considered as the use not in compliance with the
intended use.
The manufacturer is not liable for material
damage or damage to person caused by
misapplication or incorrect application of the
appliance.
Any maintenance work that requires special
technical licence or special skills may be
performed by qualified personnel only.
To provide hygiene and protect foods from dirt, all
the elements that have direct or indirect contact
with the foods and all border areas must be
thoroughly cleaned. Use only the cleaning agents
intended for use in contact with food and avoid
using flammable agents or harmful to health.
After each use of the appliance make sure that all
the heating elements and control elements have
been switched off and the cable unplugged.
In case of prolonged interval in using the
appliance disconnect all power supply cables and
thoroughly clean the inside and outside elements
of the appliance.
In direct connection to the mains the
safety switch should be supplied where wire
joints dilation is large enough to secure
disconnection in category III overvoltage,
which is in accordance with the installation
rules.
To avoid a risk of fire, check that the
oil level is not below the minimum level
marked in the container.
The oil change is recommended when
its colour is dark or when the smoke occurs in
the temperature 160 °C - 180 °C. The
frequently used oil has low ignition
temperature.
Remember that the food that is too
moist, or the load that is too high may cause
the oil to boil unexpectedly.
Use the oils or oil mixtures that are
intended for use in deep fryers.
Pay extra attention to the floor around
the appliance that may be slippery.
You must not clean the appliance with
the direct stream of water.
.