Barry-Wehmiller Thiele Technologies Streamfeeder Reliant..., Руководство пользователя

Страница: 42 / 72

36 R
eliant
1500 M
anual
Visual Inspection
(continued)
Standard
O-Ring Gate
Standard O-Ring Gate: Adjusting Worn
O-Rings
To adjust worn O-rings on standard O-ring gate:
1. Turn Off feeder and remove power cord from outlet.
2. Move the feeder back from the gate plate to allow working
clearance. You can save much re-alignment time if you mark
the current position on the back deck plate before moving.
3. Remove gate assembly from gate bracket assembly.
4. Insert a screwdriver in slot on top of gate assembly and rotate
screwdriver clockwise or counter-clockwise 360° so as to
move worn area of O-ring about 1/8 to 1/4 in. (3 to 6 mm).
See Figure 40.
5. Remove screwdriver and repeat for each ring as necessary.
6. Reinstall gate assembly and restore power.
7. Return feeder to original position marked on back deck plate.
Restore power.
Flattened
edge rotated
1/8 to 1/4"
(3 to 6 mm)
Figure 40. Adjusting Worn O-Rings
Bar Gate
Replacing Worn Angled Wedge
To replace a worn angled wedge:
1. Turn Off feeder and remove power cord from outlet.
2. Move the feeder back from the gate plate to allow working
clearance. You can save much re-alignment time if you mark
the current position on the back deck plate before moving.
3. Remove gate assembly from gate bracket assembly.
4. Use a pliers to grip and remove angled wedge. See Figure 41.
5. Install new wedge by inserting one end and then pushing in
until centered. Do not grip new wedge with pliers as this may
cause damage to the edge.
6. Reinstall gate assembly.
7. Return feeder to original position marked on back deck plate.
Restore power.
Remove angled
wedge and replace
Figure 41. Replacing Worn Angled
Wedge