Barry-Wehmiller Thiele Technologies Streamfeeder Reliant..., Руководство пользователя

Страница: 13 / 72

7
R
elaint
1500 M
anual
2
Installing the Machine
Installation of the Reliant 1500 Universal Friction Feeder onto the
back deck plate of an inserter is a relatively simple procedure, with
only minor modifications to the selected insert station prior to attach -
ing the feeder. The entire installation can typically be done with a hex-
head driver set and a slotted screwdriver.
To install the feeder, perform the following steps:
1: Removing rear guide assembly
2: Removing T-plate
3: Repositioning separator foot
4: Removing suction cup and closing off vacuum hose
5: Repositioning insert guide tabs
Optional step: Install insert plate guide
6: Installing feeder hold-down spring assemblies
7: Aligning feeder with insert station
8: Securing feeder to inserter
9: Initial feeder photo sensor positioning
! ! !
When performing initial installation, always
make sure you turn Off the main power
switch and disconnect all equipment from
the electrical power source. Failure to do so
can expose you to a potential start-up, and
therefore moving parts which can cause
serious injury.
Do not attempt feeder installation while the
inserter is running. Failure to do so can expose
you to moving parts which can cause serious
injury.
Avoid turning on the feeder or making initial
adjustments until all parts are secured. Failure
to do so can cause damage to equipment.
STEP 1:
Removing Rear
Guide Assembly
At the selected insert station, remove the fasteners that hold the
inserter rear guide assembly to the inserter back deck plate. Lift rear
guide assembly off of back deck plate (Figure 5).
Figure 5. Removing Guide Assembly Rear from Inserter
Rear guide
assembly