Barry-Wehmiller Thiele Technologies Streamfeeder Reliant..., Руководство пользователя

Страница: 35 / 72

29
R
elaint
1500 M
anual
Section 4 Troubleshooting
STEP 4:
Cycling the Inserter
• Jog the inserter to see if hold-down spring pressure is equal. Any
unequal spring pressure will skew material in the jaw.
• With the feeder already fully loaded and powered On, run the in -
serter through several cycles (Figure 33).
• Check material alignment to make sure it is consistent with the grip
position.
It might be helpful to know that a properly set
gap will allow the leading edge of sheet to enter
at about the center line of the cylinder (refer back
to Figure 28), as the previous or bottom sheet is
exiting the gate assembly area.
TIP
If a jam occurs during operation, follow these
steps:
1. Turn the feeder power Off by pushing the
circle ( O ) at the Power On/Off rocker
switch.
2. Remove jammed material from feeder.
While doing so, try to determine the
cause of the jam (see Section 5, “Trouble-
shooting”).
3. Verify whether any adjustments are loose.
If so, refer back to Section 3, “Preparing
for Operation”, for proper adjustment
procedures.
4. Reposition photo sensor (as required).
STEP 5:
Final Check
Make sure:
• Leading edge of bottom sheet stops at proper location.
• Proper separation is occurring at gate assembly area.
• Effective preshingling is occurring at curvature of gate assembly.
• Material is not being damaged during cycling.
• Feeder is secured to inserter and will not move during operation.
Figure 33. Cycling Inserter
Shutdown
Should you not be using the feeder for long periods of time, follow
these steps to ensure a safe and secure storage:
1. Turn the feeder power Off by pushing the circle ( O ) at the
rocker
Power
On/Off rocker switch.
2. Disconnect the feeder power cord from the AC power source.
3. Cover the feeder with a cloth or plastic tarp to prevent dust
and debris from accumulating.
CHECK
Insert Track
Feeder x
Station x