Barry-Wehmiller Thiele Technologies Streamfeeder Reliant..., Руководство пользователя

Страница: 10 / 72

4 R
eliant
1500 M
anual
Feature Description
Gate assembly and adjustment Mounted on a gate bracket assembly directly above the feed belts, this
device provides a curvature to help preshingle stacked material. When
properly adjusted, a clearance is created to help singulate and feed
material. (Note: For multiple page material, a 1 to 1.5 maximum thickness
is typical.)
Top panel (table top) Used to support the back wedge.
Side guides (adjustable)
Holds a stack of material to be fed and helps keep it straight for proper
entry through the gate assembly area. Also referred to as “hopper”.
(Note: Loading can be performed from either the front or back of inserter.)
Back wedge and adjustment Lifts the material to keep it off the table top, reduces excessive contact
with the feed belts, and helps push the material against the curvature of
the gate assembly.
Photo Sensor and flex arm extension Controls the starting and stopping of a feed cycle by sensing the presence
or absence of material. To ensure proper alignment of the sensor, a flex
arm extension allows you adjust it for proper distance and angle to the
material.
Feed belts Provides the friction and motion necessary to pull individual material from
the bottom of the stack and through the gate assembly area.
Discharge assist assembly A series of small rollers mounted on movable brackets help to gently hold
material down on the feed belts as material exits the gate assembly area.
These brackets and rollers are part of the gate assembly and are removed
when the gate assembly is removed.
On/Off switch (not pictured) Located on the rear of the feeder, this toggle switch turns AC power On or
Off to the feeder.
Hold-down spring assemblies As a piece of material exits the feeder gate assembly area, these two
hold-down spring assemblies help keep it aligned and in proper position
for the gripper jaw. Shipped loose and mounted on inserter.
Side guide wing-nut assmblies Secures side guides to the cross-bar. Loosening each allows you to move
each side guide horizontally to accommodate various material sizes.
Insert plate guide This plate is supplied with your feeder and is to be mounted on the back
deck plate. Shipped loose and mounted on inserter (if required).
AC power cord, 8 ft. (2.44 m) IEC320 removal three-prong. Shipped loose.
Product Description Section 1
Table 1. Feature Descriptions of Reliant 1500 Universal Friction Feeder