Barry-Wehmiller Thiele Technologies Streamfeeder Reliant..., Руководство пользователя

Страница: 38 / 72

32 R
eliant
1500 M
anual
6. Too much weight in hopper.
1. Exessive weight in hopper.
2. Excessive down pressure on gate
assembly.
3. Off-centered product from center point of
machine.
4. Stack is bearing down on edge of belt.
5. Belt wear.
6. Rollers out of adjustment.
1. Improper adjustment in any of the
following areas:
• Gate assembly
• Back wedge
• Hold-down assembly
1. Photo sensor "staging" leading edge of
material too short of hopper plate.
2. Gripper jaw adjusted too far from edge of
hopper plate.
1. Photo sensor "staging" leading edge of
material too far past hopper plate.
2. Gripper jaw adjusted too close to edge of
hopper plate.
1. Back wedge not adjusted properly.
2. Hold down spring too tight or too loose.
1. Sensor not seeing space between feeds.
Remove material from stack. Test again.
Reduce weight. Test again.
Rotate clockwise 1/8 turn to increase gap
and manually test. Review gate assembly
adjustment in Section 3 "Preparing for
Operation".
Review side guide setting in Section 3 "Pre-
paring for Operation".
Move stack away from belt, even if this
causes stack to be aligned off-center from
machine center line.
Review gate assembly adjustment in Sec-
tion 3 "Preparing for Operation". See also
Section 6 "Inspection and Care". If wear is
excessive, consult with a qualified techni -
cian.
Consult with a qualified technician.
1. Turn the power switch to "Off".
2. Remove jammed material. Attempt to
determine the cause of the jam.
3. Verify each adjustment by reviewing Sec-
tion 3 "Preparing for Operation".
Review photo sensor adjustment in Section
3 "Preparing for Operation".
Adjust gripper jaw per inserter owner's
manual instructions.
Review photo sensor adjustment in Section
3 "Preparing for Operation".
Adjust gripper jaw per inserter owner's
manual instructions.
Review back wedge adjustment in Section 3
" Preparing for Opertion".
Review hold-down spring installation in Sec-
tion 2 "Installing the Machine".
Reposition sensor. Review photo sensor
adjustment in Section 3: "Preparing for
Operation".
Table 2. Quick-Look Troubleshooting (continued)
Feed belts are operat -
ing but material not
feeding (cont)
Feed belts not tracking
on rollers
Jamming occurs during
operation
Material too far from
gripper jaw
Material too deep in
gripper jaw
Material skewing
Motor not "staging"
new material
Problem Cause Solution